Control Bus Analysing
Bus Health mode allows for an analysis of the signal quality on an industrial network, comparing measured signals to the standards' signal requirements. We use the Fluke 125 to deal with industrial machinery and the industrial network connecting this machinery and the like.
Bus Health mode gives a clear "Good" / "Bad" indication for the electrical signals on industrial buses and networks, such as CAN-bus, Profi-bus, RS-232 and many more. Our Equipment validates the quality of the electrical signals as soon as any electrical signals are passed along the network. It checks the signal levels and speed, transition times and distortion, and compares these to the appropriate standards to help you find errors like improper cable connections and terminators. It helps you find the source of error in case communication comes to a halt. All the commonly found industrial network types are supported.
- Harmonics mode graphically displays harmonics up to the 33rd harmonic to assist in fault-finding, e.g. with large non-linear loads.
- RPM and Hz reading for use with electrical and combustion engines.
- Vac pwm for use on motor drive outputs, reading the true output voltage experienced by the motor itself.
- Low impedance measurements giving a 0.01 ohms resolution for motor windings and the like.
- Industrial Network Bus Health mode
- High resolution, low impedance measurements
- Reading of Hz and Rotations Per Minute (RPM)
- Measurement of Vpwm for use on motor drive outputs
- Full hardc
opy reports provided
 |  |